Diesel Engine Maintenance Tips
Please note that regular maintenance is the best way of ensuring your engine lasts as long as possible. Engine oil is very important when you use diesel generator. Make sure you will buy a good quality oil since the poor quality oil can increase oil viscosity during service life leading to insufficient lubrication during start up and operation. To protect your machine running well, a good maintenance is necessary and important. 1. Inspect your cooling system coolant level. 2. Inspect your engine oil level. 3. Check your fuel system primary filter. 4. Make sure the oil filters you use meet or exceed the OEM filter recommended by the vehicle manufacturer. 5. Whenever you stop at the pump for fuel try to add a bottle of diesel treatment. This helps keep impurities in the fuel from reaching your engine.
6. Check the oil level of the fuel injection pump governor. The oil level should reach the mark on the oil dipstick. Add enough amount if necessary.
7. Check the installation of diesel engine accessories. Including the stability of the accessories installation and the reliability of the connection between the foundation bolt and the machine.
8. Check the instrument. Observe whether the instrument reading is normal or not. If it is not normal, repair or replace it timely.
9. Check the fuel injection pump transmission connection plate. Whether the connection screw is loose or not, if it is loose, proofread the fuel injection advance angle and tighten the fitting screw.
10. Clean air filter. For the inertia oil bath type air filter, you should clean the steel wire core and replace the engine oil. For basin (cyclone) type air filter, you should clean the dust on the dust collection plate and maintain the paper filter element.
11. Do not put fuel in the tank while the engine runs - unless it is absolutely necessary - because it can introduce air into the fuel system.
12. Do not allow dirt to enter the fuel system. Before a connection is disconnected, clean the area around the connection thoroughly. After a component has been disconnected, fit a suitable cover to all open connections.
Besides, always check the condition of 0-rings and rubber seals when filters or plugs are removed, and consider replacement. Sump plug seals should be changed every oil change.